Step 1.)
Power Vacuum

It is important to vacuum loose dust and dirt from the carpet fibre while it is completely dry. A power vacuum is an upright vacuum with powered brush head that gets deep into the pile and between the carpet fibres for a deep vacuum

Step 2.)
Pre Spray and treatment of stains

A broad-spectrum stain remover is applied to the carpet with specific attention to the ' High Traffic areas' The stain remover is left for 5- 7 minutes to break down soiling, dirtnd stains

Step 3.)
Rotary agitation of 'Traffic' areas

Using a rotary floor machine with a nylon pad/brush the stain remover is worked into the pile. This process makes a huge difference to results and is the difference between our cleaning and most carpet cleaning. In most high 'traffic' areas the carpet in flattened and worn. This process lifts the carpet pile allowing the stain removers to penetrate deep into the pile. The rotating action agitates and assists the stain remover in loosening soiling and stains ready for removal by steam cleaning in the final stage.

Step 4.)
Steam Cleaning and Deodorising

The loosened soiling and dirt is rinsed out and removed by a Hot water (steam) and extraction (wet vacuum) machine. This is either portable or a truck mounted unit. This process happens simultaneously meaning the hot water is not on the carpet long enough to soak in or through to the carpet backing. The carpet is not left wet. Done correctly the carpet is lightly damp and clean and will be completely dry in 2- 4 hours depending on the wool content.